Dana 44 Gear Ratio Chart

Dana 44 Gear Ratio Chart – The gear ratio at which carrier breaks occur varies, depending on the type of differential. You have a dana 30 with 3.08 ratio, but. The general rule of thumb for any 4×4 vehicle is for the front and rear ratios to be within 2% of each other (this amount is easily absorbed within the backlashes in the drivetrain) and. 3.07, 3.31, 3.54, 3.73, 4.09, 4.27, and 4.54 for normal use.

For example, if you have a dana 44 axle with a gear ratio. Dana 44 rear ends have two carrier sizes or breaks; 8.5 / 216mm pinion diameter /. A pair of carrier sizes splits these offerings.

Dana 44 Gear Ratio Chart

The sustained torque rating would actually be much less. Last edited by studerich ; The number can usually be found on the lower right side rib below the differential cover, but it may also be.

You can download this chart in pdf form by clicking here: Note that all dana 44 axles feature a 3.73/3.92 carrier break. Any gear size from 2.72:1 to 3.73:1 will use one carrier, gears from 3.92:1 up to 5.89:1 use another.

Differentials designed for 3.73 and numerically lower gears require thick gears for 3.92 and higher ratios. New_gen_dana_44_comparison_chart_dynatrac here’s where it gets. Dana 44 axles used in ’60’s studebakers came in:

Dana 30 3.55 and down, 3.73 and up dana 35 3.08 and down, 3.55 and up dana 44 4.88 and down, 4.89 and up example: If you change the ratio to a 4.09, you must change to a high. This article about an automotive part or component is a stub.

dana 44 axels and hubs